Partial
ELEGOO PET-CF on the Kobra 3 Max
FilamentFacts may earn a commission when you buy through links on this page. As an Amazon Associate we earn from qualifying purchases.
- Nozzle260–290 °C
- Bed90–110 °C
- Speed—
- Dry85 °C maximum
- Density1.32 g/cm³
Print at 260–290 °C nozzle, 90–110 °C bed. Dry at 85 °C if it's been open. No drying time on the source.
Kobra 3 Max maximums: nozzle 300 °C, bed 90 °C.
Sources & notes
Anycubic Kobra 3 Max with ELEGOO PET-CF: The listed bed range reaches 110 °C, above this printer's maximum of 90 °C. This printer cannot reach the full recommended range. The low end, 90 °C, is within that maximum.
Dataset imported 13 October 2026. Manufacturer page checked 14 October 2026.
Filament source · Printer source · Filament JSON
The quick start lists a 300 °C maximum nozzle temperature and a 90 °C maximum heatbed temperature. The Combo includes the ACE Pro.
The FAQ recommends setting up a warm chamber for ABS, so the stock printer is recorded as open. Nozzle alloy and drive type are not stated.
Questions
Can the Anycubic Kobra 3 Max reach the listed PET-CF nozzle temperature?
The listed nozzle maximum of 290 °C is within this printer's maximum of 300 °C.
Can the Kobra 3 Max reach the listed bed temperature?
The listed bed range reaches 110 °C, above this printer's maximum of 90 °C. This printer cannot reach the full recommended range. The low end, 90 °C, is within that maximum.
Is an enclosure required?
Whether an enclosure is required is not in our current sources.
Is a hardened nozzle recorded?
This filament is carbon-fiber, glass-fiber, or glow-in-the-dark, so a hardened nozzle is the upgrade to check. Whether the stock nozzle is hardened is not in our current sources.