Eryone PLA Metallic on the H2D
FilamentFacts may earn a commission when you buy through links on this page. As an Amazon Associate we earn from qualifying purchases.
- Nozzle—
- Bed—
- Speed—
- Dry75 °C (167 °F) maximum
- Density1.23 g/cm³
No nozzle or bed temperature on the source. Dry at 75 °C (167 °F) if it's been open. No drying time on the source.
H2D maximums: nozzle 350 °C (662 °F), bed 120 °C (248 °F).
Sources & notes
Bambu Lab H2D with Eryone PLA Metallic: Nozzle temperature is not in our current sources.
Dataset imported 13 October 2026. Manufacturer page checked 15 October 2026.
Filament source · Printer source · Filament JSON
The H2D technical specifications list a hardened steel nozzle, a 350 °C maximum nozzle temperature, and a 120 °C maximum heatbed temperature.
The same table lists active chamber heating to 65 °C, a door sensor, and a shell of aluminum, steel, plastic, and glass. The product page describes a chamber with doors.
Filament odometry is listed as supported with AMS. The specification does not say an AMS unit is included, and it does not name the extruder direct drive.
Questions
Can the Bambu Lab H2D reach the listed PLA Metallic nozzle temperature?
Nozzle temperature is not in our current sources.
Can the H2D reach the listed bed temperature?
Bed temperature is not in our current sources.
Is an enclosure required?
Whether an enclosure is required is not in our current sources.
Is a hardened nozzle recorded?
A hardened nozzle is not recorded for this filament.