Partial
extrudr DuraPro ASA on the P1S
FilamentFacts may earn a commission when you buy through links on this page. As an Amazon Associate we earn from qualifying purchases.
- Nozzle235–260 °C (455–500 °F)
- Bed90–110 °C (194–230 °F)
- Speed—
- Dry—
- Density1.07 g/cm³
Print at 235–260 °C (455–500 °F) nozzle, 90–110 °C (194–230 °F) bed.
P1S maximums: nozzle 300 °C (572 °F), bed 100 °C (212 °F).
Sources & notes
Bambu Lab P1S with extrudr DuraPro ASA: The listed bed range reaches 110 °C (230 °F), above this printer's maximum of 100 °C (212 °F). This printer cannot reach the full recommended range. The low end, 90 °C (194 °F), is within that maximum.
Dataset imported 13 October 2026. Manufacturer page checked 14 October 2026.
Filament source · Printer source · Filament JSON
The P1S specification table lists a stainless steel nozzle, a 300 °C maximum hot end, and a 100 °C maximum build plate. The shell is plastic and glass.
Bambu Lab describes the P1S as a fully enclosed body and says fiber-reinforced filament is not recommended until the extruder and hotend are upgraded.
The P1 series page describes a direct-drive extruder and AMS multi-color printing.
Questions
Can the Bambu Lab P1S reach the listed DuraPro ASA nozzle temperature?
The listed nozzle maximum of 260 °C (500 °F) is within this printer's maximum of 300 °C (572 °F).
Can the P1S reach the listed bed temperature?
The listed bed range reaches 110 °C (230 °F), above this printer's maximum of 100 °C (212 °F). This printer cannot reach the full recommended range. The low end, 90 °C (194 °F), is within that maximum.
Is an enclosure required?
Whether an enclosure is required is not in our current sources.
Is a hardened nozzle recorded?
A hardened nozzle is not recorded for this filament.