Partial
Bambu Lab ABS-GF on the K1C
FilamentFacts may earn a commission when you buy through links on this page. As an Amazon Associate we earn from qualifying purchases.
- Nozzle230–260 °C (446–500 °F)
- Bed90–110 °C (194–230 °F)
- Speedup to 180 mm/s
- Dry80 °C (176 °F) for 8 h
- Density1.08 g/cm³
Print at 230–260 °C (446–500 °F) nozzle, 90–110 °C (194–230 °F) bed. Dry 8 h at 80 °C (176 °F) if it's been open. Listed speed up to 180 mm/s.
K1C maximums: nozzle 300 °C (572 °F), bed 100 °C (212 °F).
Sources & notes
Creality K1C with Bambu Lab ABS-GF: The listed bed range reaches 110 °C (230 °F), above this printer's maximum of 100 °C (212 °F). This printer cannot reach the full recommended range. The low end, 90 °C (194 °F), is within that maximum.
Dataset imported 13 October 2026. Manufacturer page checked 14 October 2026.
Filament source · Printer source · Filament JSON
Creality lists nozzle temperature ≤300 °C, heatbed temperature ≤100 °C, a dual-gear direct drive extruder, a hardened steel nozzle tip, and an enclosed design with a glass door.
Questions
Can the Creality K1C reach the listed ABS-GF nozzle temperature?
The listed nozzle maximum of 260 °C (500 °F) is within this printer's maximum of 300 °C (572 °F).
Can the K1C reach the listed bed temperature?
The listed bed range reaches 110 °C (230 °F), above this printer's maximum of 100 °C (212 °F). This printer cannot reach the full recommended range. The low end, 90 °C (194 °F), is within that maximum.
Is an enclosure required?
Whether an enclosure is required is not in our current sources.
Is a hardened nozzle recorded?
This filament is recorded as needing a hardened nozzle. The stock nozzle is hardened.