Partial

ELEGOO PET-CF on the K1C

FilamentFacts may earn a commission when you buy through links on this page. As an Amazon Associate we earn from qualifying purchases.

Nozzle260–290 °C
Bed90–110 °C
Speed—
Dry85 °C maximum
Density1.32 g/cm³

Print at 260–290 °C nozzle, 90–110 °C bed. Dry at 85 °C if it's been open. No drying time on the source.

Nozzle260–290 °C

Bed90–110 °C

Shared scale, 0–320 °C. A missing bar means the manufacturer did not publish that temperature.

K1C maximums: nozzle 300 °C, bed 100 °C.

Filament page · K1C

Sources & notes

Creality K1C with ELEGOO PET-CF: The listed bed range reaches 110 °C, above this printer's maximum of 100 °C. This printer cannot reach the full recommended range. The low end, 90 °C, is within that maximum.

Dataset imported 13 October 2026. Manufacturer page checked 14 October 2026.

Filament source · Printer source · Filament JSON

Creality lists nozzle temperature ≤300 °C, heatbed temperature ≤100 °C, a dual-gear direct drive extruder, a hardened steel nozzle tip, and an enclosed design with a glass door.

Questions

Can the Creality K1C reach the listed PET-CF nozzle temperature?

The listed nozzle maximum of 290 °C is within this printer's maximum of 300 °C.

Can the K1C reach the listed bed temperature?

The listed bed range reaches 110 °C, above this printer's maximum of 100 °C. This printer cannot reach the full recommended range. The low end, 90 °C, is within that maximum.

Is an enclosure required?

Whether an enclosure is required is not in our current sources.

Is a hardened nozzle recorded?

This filament is carbon-fiber, glass-fiber, or glow-in-the-dark, so a hardened nozzle is the upgrade to check. The stock nozzle is hardened.