Partial
Siraya Tech Fibreheart PET-GF on the K1C
FilamentFacts may earn a commission when you buy through links on this page. As an Amazon Associate we earn from qualifying purchases.
- Nozzle300–320 °C
- Bed80 °C
- Speed—
- Dry—
- Density1.3 g/cm³
Print at 300–320 °C nozzle, 80 °C bed.
K1C maximums: nozzle 300 °C, bed 100 °C.
Sources & notes
Creality K1C with Siraya Tech Fibreheart PET-GF: The listed nozzle range reaches 320 °C, above this printer's maximum of 300 °C. This printer cannot reach the full recommended range. The low end, 300 °C, is within that maximum.
Dataset imported 13 October 2026. Manufacturer page checked 14 October 2026.
Filament source · Printer source · Filament JSON
Creality lists nozzle temperature ≤300 °C, heatbed temperature ≤100 °C, a dual-gear direct drive extruder, a hardened steel nozzle tip, and an enclosed design with a glass door.
Questions
Can the Creality K1C reach the listed Fibreheart PET-GF nozzle temperature?
The listed nozzle range reaches 320 °C, above this printer's maximum of 300 °C. This printer cannot reach the full recommended range. The low end, 300 °C, is within that maximum.
Can the K1C reach the listed bed temperature?
The listed bed maximum of 80 °C is within this printer's maximum of 100 °C.
Is an enclosure required?
Whether an enclosure is required is not in our current sources.
Is a hardened nozzle recorded?
This filament is recorded as needing a hardened nozzle. The stock nozzle is hardened.