Partial
Bambu Lab PC on the SV08 Max
FilamentFacts may earn a commission when you buy through links on this page. As an Amazon Associate we earn from qualifying purchases.
- Nozzle260–300 °C (500–572 °F)
- Bed100–120 °C (212–248 °F)
- Speedup to 200 mm/s
- Dry80 °C (176 °F) for 8 h
- Density1.2 g/cm³
Print at 260–300 °C (500–572 °F) nozzle, 100–120 °C (212–248 °F) bed. Dry 8 h at 80 °C (176 °F) if it's been open. Listed speed up to 200 mm/s.
SV08 Max maximums: nozzle 300 °C (572 °F), bed 100 °C (212 °F).
Sources & notes
Sovol SV08 Max with Bambu Lab PC: The listed bed range reaches 120 °C (248 °F), above this printer's maximum of 100 °C (212 °F). This printer cannot reach the full recommended range. The low end, 100 °C (212 °F), is within that maximum.
Dataset imported 13 October 2026. Manufacturer page checked 14 October 2026.
Filament source · Printer source · Filament JSON
Sovol lists nozzle temperature ≤300 °C and hot bed temperature ≤100 °C, plus an optional chamber heating module and an enclosure kit.
Sovol's product note describes a dual-gear direct drive extruder. Nozzle alloy is not stated.
Questions
Can the Sovol SV08 Max reach the listed PC nozzle temperature?
The listed nozzle maximum of 300 °C (572 °F) is within this printer's maximum of 300 °C (572 °F).
Can the SV08 Max reach the listed bed temperature?
The listed bed range reaches 120 °C (248 °F), above this printer's maximum of 100 °C (212 °F). This printer cannot reach the full recommended range. The low end, 100 °C (212 °F), is within that maximum.
Is an enclosure required?
Whether an enclosure is required is not in our current sources.
Is a hardened nozzle recorded?
A hardened nozzle is not recorded for this filament.