Partial
Bambu Lab PA6-GF on the A1 mini
FilamentFacts may earn a commission when you buy through links on this page. As an Amazon Associate we earn from qualifying purchases.
- Nozzle250–290 °C (482–554 °F)
- Bed80–100 °C (176–212 °F)
- Speedup to 130 mm/s
- Dry80 °C (176 °F) maximum
- Density1.14 g/cm³
Print at 250–290 °C (482–554 °F) nozzle, 80–100 °C (176–212 °F) bed. Dry at 80 °C (176 °F) if it's been open. No drying time on the source. Listed speed up to 130 mm/s.
A1 mini maximums: nozzle 300 °C (572 °F), bed 80 °C (176 °F).
Sources & notes
Bambu Lab A1 mini with Bambu Lab PA6-GF: The listed bed range reaches 100 °C (212 °F), above this printer's maximum of 80 °C (176 °F). This printer cannot reach the full recommended range. The low end, 80 °C (176 °F), is within that maximum.
Dataset imported 13 October 2026. Manufacturer page checked 14 October 2026.
Filament source · Printer source · Filament JSON
Bambu Lab lists a 300 °C maximum hot end temperature, an 80 °C maximum build plate temperature, and a stainless steel nozzle.
The FAQ says a hardened steel nozzle is required for carbon-fiber or glass-fiber filament and is not the pre-installed nozzle.
Enclosure is not stated on the specification table checked here.
Questions
Can the Bambu Lab A1 mini reach the listed PA6-GF nozzle temperature?
The listed nozzle maximum of 290 °C (554 °F) is within this printer's maximum of 300 °C (572 °F).
Can the A1 mini reach the listed bed temperature?
The listed bed range reaches 100 °C (212 °F), above this printer's maximum of 80 °C (176 °F). This printer cannot reach the full recommended range. The low end, 80 °C (176 °F), is within that maximum.
Is an enclosure required?
Whether an enclosure is required is not in our current sources.
Is a hardened nozzle recorded?
This filament is recorded as needing a hardened nozzle. The stock nozzle is not hardened.