Bambu Lab Support for ABS on the A1
FilamentFacts may earn a commission when you buy through links on this page. As an Amazon Associate we earn from qualifying purchases.
- Nozzle—
- Bed80–100 °C
- Speedup to 100 mm/s
- Dry80 °C for 4 h
- Density1.16 g/cm³
Bed 80–100 °C. No nozzle temperature on the source. Dry 4 h at 80 °C if it's been open. Listed speed up to 100 mm/s.
A1 maximums: nozzle 300 °C, bed 100 °C.
Sources & notes
Bambu Lab A1 with Bambu Lab Support for ABS: Nozzle temperature is not in our current sources.
Dataset imported 13 October 2026. Manufacturer page checked 14 October 2026.
Bambu Lab Support for ABS technical data sheet · checked 14 October 2026 · Printer source · Filament JSON
The A1 FAQ states a maximum hotend temperature of 300 °C and a maximum heatbed temperature of 100 °C.
The same FAQ says the printer is pre-installed with a 0.4 mm stainless steel nozzle. Hardened steel nozzles are sold separately.
The FAQ does not call the frame open or enclosed, so enclosure is left empty.
Questions
Can the Bambu Lab A1 reach the listed Support for ABS nozzle temperature?
Nozzle temperature is not in our current sources.
Can the A1 reach the listed bed temperature?
The listed bed maximum of 100 °C is within this printer's maximum of 100 °C.
Is an enclosure required?
Whether an enclosure is required is not in our current sources.
Is a hardened nozzle recorded?
A hardened nozzle is not recorded for this filament.