Bambu Lab Support for ABS on the P1S
FilamentFacts may earn a commission when you buy through links on this page. As an Amazon Associate we earn from qualifying purchases.
- Nozzle—
- Bed80–100 °C
- Speedup to 100 mm/s
- Dry80 °C for 4 h
- Density1.16 g/cm³
Bed 80–100 °C. No nozzle temperature on the source. Dry 4 h at 80 °C if it's been open. Listed speed up to 100 mm/s.
P1S maximums: nozzle 300 °C, bed 100 °C.
Sources & notes
Bambu Lab P1S with Bambu Lab Support for ABS: Nozzle temperature is not in our current sources.
Dataset imported 13 October 2026. Manufacturer page checked 14 October 2026.
Bambu Lab Support for ABS technical data sheet · checked 14 October 2026 · Printer source · Filament JSON
The P1S specification table lists a stainless steel nozzle, a 300 °C maximum hot end, and a 100 °C maximum build plate. The shell is plastic and glass.
Bambu Lab describes the P1S as a fully enclosed body and says fiber-reinforced filament is not recommended until the extruder and hotend are upgraded.
The P1 series page describes a direct-drive extruder and AMS multi-color printing.
Questions
Can the Bambu Lab P1S reach the listed Support for ABS nozzle temperature?
Nozzle temperature is not in our current sources.
Can the P1S reach the listed bed temperature?
The listed bed maximum of 100 °C is within this printer's maximum of 100 °C.
Is an enclosure required?
Whether an enclosure is required is not in our current sources.
Is a hardened nozzle recorded?
A hardened nozzle is not recorded for this filament.