Partial
Bambu Lab Support for ABS on the A1 mini
FilamentFacts may earn a commission when you buy through links on this page. As an Amazon Associate we earn from qualifying purchases.
- Nozzle—
- Bed80–100 °C
- Speedup to 100 mm/s
- Dry80 °C for 4 h
- Density1.16 g/cm³
Bed 80–100 °C. No nozzle temperature on the source. Dry 4 h at 80 °C if it's been open. Listed speed up to 100 mm/s.
A1 mini maximums: nozzle 300 °C, bed 80 °C.
Sources & notes
Bambu Lab A1 mini with Bambu Lab Support for ABS: The listed bed range reaches 100 °C, above this printer's maximum of 80 °C. This printer cannot reach the full recommended range. The low end, 80 °C, is within that maximum.
Dataset imported 13 October 2026. Manufacturer page checked 14 October 2026.
Bambu Lab Support for ABS technical data sheet · checked 14 October 2026 · Printer source · Filament JSON
Bambu Lab lists a 300 °C maximum hot end temperature, an 80 °C maximum build plate temperature, and a stainless steel nozzle.
The FAQ says a hardened steel nozzle is required for carbon-fiber or glass-fiber filament and is not the pre-installed nozzle.
Enclosure is not stated on the specification table checked here.
Questions
Can the Bambu Lab A1 mini reach the listed Support for ABS nozzle temperature?
Nozzle temperature is not in our current sources.
Can the A1 mini reach the listed bed temperature?
The listed bed range reaches 100 °C, above this printer's maximum of 80 °C. This printer cannot reach the full recommended range. The low end, 80 °C, is within that maximum.
Is an enclosure required?
Whether an enclosure is required is not in our current sources.
Is a hardened nozzle recorded?
A hardened nozzle is not recorded for this filament.